Installation plan
Show the client where the sockets, switches and lights will go. On the same plan, review the cable routes and their lengths.
You draw the floor plan with real dimensions. Every room gets its area on the plan, so DINPanel knows where each point and circuit belongs.
Move a socket on the plan and you can still see which circuit it belongs to. It is easier to agree a change with the client and check its effect on the installation.
Cables enter each point at a right angle to the nearest wall and follow the walls to the switchboard. In the floor view you can shape a route with control points or group cables into a shared bundle.
DINPanel measures each cable along its route and adds the mounting heights, the route level and the allowances. The lengths go straight into the material list.
Have a kitchen lighting circuit but no light point on the plan? DINPanel points it out before you show the drawing to the client.
Instead of explaining where a switch goes or how a cable runs, show the client in the 3D view.
Every part comes from the plan or the project settings. You can change the allowances.
Route on the plan + Mounting heights + Passages between floors + 1 m at the switchboard + 0.4 m per cable end = Cable length in the material list
Add the walls, doors and windows of each floor.
Assign an area of the plan to each room of the building.
Put sockets, switches and lights on the room plan and connect them into circuits.
Review the routes, the cable lengths and the 3D view, then export the plan.
The plan is part of the project, so its data is used everywhere else. Click to see a real page from the demo project.
The circuits you draw on the plan go straight into the switchboard design. You do not enter them twice.
No. You can work with the circuit list only. The plan adds the point layout, cable routes, calculated lengths and the 3D view.
It measures the route shown on the plan and adds the mounting heights of the points, the route level and the passages between floors. It also adds an allowance at the switchboard and at each cable end. The default allowances are 1 m and 0.4 m and can be changed.
Yes. A length you enter stays in force. After a route change, DINPanel offers a recalculation, and you decide whether to accept it.
Yes. Each floor has its own plan. Cables between floors go through passages that you place at the floor or the ceiling.
Yes. You can export the plan to PDF and show the installation in the interactive 3D view.
Open the planner demo in your browser. No registration.
Try the planner demo Start for free