Switchboard design
Build a switchboard layout from the project circuits, see the load on each phase and check the connections. Want a different arrangement? Move the devices and change the wiring yourself.
Choose how to protect the circuits and DINPanel prepares the first device layout. Instead of starting with an empty DIN rail, you have a design to review and adjust.
See how much load falls on L1, L2 and L3. When you change circuits or devices, you can check the effect on the phase balance straight away.
DINPanel checks the logic of the connections, not only the drawing. For every problem it explains the cause and suggests what to change. A click on the problem shows the module, even in a large switchboard.
Click a circuit to see its phase path through the protection devices to the supply. Click again to see all conductors, including neutral and protective earth.
The automatic layout is a starting point. Move a device, change a connection or build the whole switchboard yourself.
Enter the circuits of the rooms, or skip this step and start directly in the switchboard.
Main isolator, surge protection and the residual current device strategy.
DINPanel places the devices, connects them and distributes the phases.
Check the result, change what you need and download the documents. You stay responsible for the final design.
All documents come from the same switchboard and carry your logo. Click to see a real page from the demo project.
Circuits from the installation plan go straight into the switchboard. The same data then builds the material list, the proposal and the documentation.
Yes. After you define the circuits, you choose the main isolator, the surge protection and the residual current device strategy. DINPanel places the devices and distributes the load across phases. You can change the result by hand, or remove it and generate it again.
No. The design uses device types, such as a miniature circuit breaker or a residual current device, with their poles and terminals. You assign products with EAN codes later, and DINPanel remembers your choices for the next projects.
Yes. You can insert every device yourself and connect it with wires or comb busbars. Circuits are not required for manual design.
For example a wrong phase connection, an overloaded miniature circuit breaker, phase and neutral routed through different residual current devices, or a conductor that does not fit a terminal. Every problem comes with a suggested fix.
Yes. The single-line schematic and the multi-line schematic are generated from the project data, on drawing sheets with a title block and your logo.
Yes. A project can contain a main switchboard and sub-boards. A sub-board is supplied by a feeder circuit from an output of its parent switchboard.
Open the demo in your browser. No registration.
Try the switchboard demo Start for free