Electrical installation design software

Record rooms, points and circuits during your first visit. Back at the office, carry on with the same project: complete the plan, switchboard, materials and quote.

Building, floors, rooms
230/400 V and low-voltage circuits
Works offline on site
Installation summary

Start for free Try the switchboard demo

From the first visit to a complete installation

Building, floors and rooms

Leave your paper notes behind. Record floors, rooms and agreements on your phone, even where there is no signal.

Living, private, wet and technical rooms
Rooms in your own order on every floor
Also without internet, synchronized later

Circuits with points, cables and loads

Add circuits room by room with ready buttons for sockets, lights and appliances. Every circuit shows its points, power, cable length and voltage drop.

Load bar against the reference power of the phase
Warnings for excessive voltage drop and cable load
See which circuits need a closer look at the load, cable or voltage drop.

Details of a circuit when you need them

The circuit editor sets each point: its cable type, cross-section, length and boxes. You can connect points in any order and change the cable between them.

Core colors of every cable
Box type for every point
Your own cables, boxes and symbols

Low-voltage systems in the same project

Alarm, CCTV, network sockets, intercom, gate control, irrigation, satellite TV, audio and fibre are circuits too. They get their own cables and appear in the material list.

Alarm sensors and reed switches
Network and fibre
Low-voltage circuits have their own group, while staying in the same project and material list.

A summary to check with the client

The project page shows the whole installation at a glance: rooms, circuits, supply, cable lengths, the switchboard and the quote value. You see at once what is still missing.

Progress of every part of the project
Electrical and low-voltage cable lengths
Quote value, net and gross

How it works

Visit the client
Note the building, rooms and circuits on your phone, even without signal.
Add the details
Cables, boxes and loads on a tablet or computer.
Design plan and switchboard
Place the points on the plan and generate the switchboard.
Quote and hand over
Send the quote, then the documentation for the client.

What the project gives you

Documents from the demo project. Click a page to see it in full size.

Installation statistics Circuits, points, boxes, loads and cable length
Material list A material list with the products and EAN codes you choose or add to your own catalog.
Floor plan Points of every room on the plan

One project, every next step

The rooms and circuits you enter here feed the plan, the switchboard and the quote. Nothing is entered twice.

Questions about installation design

Can I start a project on site without internet?

Yes. The building, floors, rooms and circuits can be entered offline. Changes are sent to the server when the connection returns.

Which circuits can I design?

Typical 230 V and 400 V circuits, and low-voltage systems such as alarm, CCTV, network sockets, intercom, gate control, irrigation, satellite TV, audio and fibre.

Does DINPanel check the circuits?

Yes. It reports warnings and errors such as an excessive voltage drop or a cable load above the configured capacity. The electrician remains responsible for the final design.

Do I have to draw a floor plan?

No. A circuit list is enough for the switchboard, the material list and the quote. The plan adds the point layout, routes and calculated cable lengths.

Can I use my own cables and boxes?

Yes. You can add cables, boxes, symbols and devices, and set your defaults so the next projects start with your usual choices.

Start your next project in DINPanel

Your first day is free.

Start for free Start for free